Stickit Pro Epoxy Tile Repair Kit - 5 kg

What's in the box

StickIt Pro Epoxy cures at any depth and can be used to re-bond and fill large gaps.
Suitable for difficult to adhere surfaces such as tile over tile, porcelain, and natural stone and can be used on damp surfaces (no pooling water).

Once cured, StickIt Pro will provide a strong yet flexible bond, ensuring that your loose tiles are securely fixed in place.
StickIt Pro dries clear in a thin film and can be used to repair waterproofing.

Available in convenient single dose packs so that you don't need to worry about measuring or weighing the adhesive in order to get the correct mixture.

Simply pour one adhesive pack (resin and hardener supplied in a twin pouch pack) into the bottle, mix by shaking rapidly for 10 seconds and you're ready to go - no epoxy mixer required

Clean-up is easy with water wash-up, so you can be done in no time.

IMPORTANT
Stickit Pro can be used on damp surfaces but is not suitable for use where there is pooling water as this will dilute the adhesive prior to cure.

A syringe with drawing up needle, wet and dry vacuum or injecting compressed air may assist in removing any pooling water prior to injection.

PRECAUTIONS
Protect or mask porous surfaces as Stickit Pro will leave a glossy clear film on exposed surfaces. Stickit pro dries clear in thin films but in thicker sections will appear white.

Stickit Pro is suitable for a wide range of surfaces but is not recommended for use on smooth plastics.

COVERAGE

Floor Tiles - Approx 5m /kg
Wall Tiles - Approx 10m /kg
Larger tiles or natural stone are typically laid with a larger notched trowel and voids can be significantly larger.

DRYING TIME
Dry - 24 hours
Fully Cured - 72 hours

CLEAN UP - Water

SHELF LIFE
24 Months - Store Below 35 C

APPLICATION TEMP.
10 C - 40 C

DRYING TIME
Stickit Pro has a pot life of 2+ hours once mixed and typically cures within 24 hours with full hardness achieved after 72 hours.

Pot life and curing times will be shorter at temperatures above 25C.

Do not use when surface temperatures fall below 5 degrees as curing will stop