Sealit - Multipurpose Sealer - 15 Litre

ACRYLIC CLEAR, WATERPROOFING COMPOUND

Shalex SealIt Multipurpose is a water based general purpose clear waterproofing compound designed for use on a wide variety of substrates.

SealIt Multipurpose is especially suited to sealing and protecting porous vertical masonry surfaces such as split faced or decorative concrete blocks. SealIt is particularly effective against wind driven rain and unlike ‘water repellent’ style sealers, can withstand hydrostatic pressures caused by significant weather events. SealIt is UV stable and provides long term protection (i.e. > 10 years)

SealIt Multipurpose dries to a clear low sheen finish and remains flexible to accommodate minor movement in the substrate. SealIt can be over painted with any acrylic paint. Due to exceptional adhesion SealIt is well suited as a primer for acrylic architectural topcoats, elastomerics and roofing paints.

SealIt is a very soft sealer and not suitable for horizontal surfaces subject to traffic (e.g. paths, pavers, floors etc) unless they are to be covered with tiles, carpet, or harder coatings.

HELPFUL TIPS!

With difficult to wet out surfaces, hot surfaces, or in very hot and windy conditions, the application of a very fine mist spray of water over the surface may help absorption prior to application of the primer coat. The surface should be just damp, not wet.

Place drop sheets down on floor surfaces to ensure no run-off or drips occur when applying SealIt Multipurpose to walls.

RECOMMENDATION

While SealIt Multipurpose is a water based waterproofing agent, we recommend the use of gloves when using this product.

The superior adhesion and water repellent properties of SealIt Multipurpose may cause 'sticky hands' even after washing well with soap and water.

IMPORTANT NOTE:

SealIt Multipurpose is not designed as a final coating for horizontal / trafficable areas and should be covered or over-coated.

Allow at least 24 hours (at 24°C) to dry before applying screeds, tiles or any other coatings or coverings.

PRODUCT FEATURES

• Tested to ASTM E514.74 - Rated 'E' for excellent on water permeance
• Excellent adhesion
• Cost effective & gives long lasting protection
• Highly flexible
• Waterborne for easy application and clean-up
• Safe to use with minimal vapor
• Dries to a clear, low-sheen finish
• May be painted over with any acrylic based paint

PRODUCT USES

• Clay & masonry bricks / blocks
• Cement render
• Concrete slabs
• Wet areas
• Fibre cement sheeting
• Leaking showers
• Particle board flooring
• Coloured masonry
• Fishponds & troughs
• Concrete tilt panels
• Terracotta pots
• Undercoats / sealer
• Concrete ponds
• Sealing screeds
• Fibro roofs

TECHNICAL DATA

DISCLAIMER

Customers are advised to consider the information in this data sheet in the context of how the product will be used, including surfaces and any other products used. The information provided in this data sheet represents our best scientific and practical knowledge. Any advice, information or assistance provided by Aqua Plastech in relation to its products is given in good faith, however, is provided without liability or responsibility. Due to the wide variety of site conditions we are unable to assume liability for any loss that may arise from the use of our products. The user is responsible for checking the suitability of products for their intended use.